Designed for heavy duty slurry and/or acid applications.
The JOLLY Series slurry pumps are custom built to customer specifications.
The shaft is always supported above the baseplate by two bearings inside the base.
The pump-motor coupling is an elastic joint or V-belt.
The maximum length of the pump under the base can reach 13–16 ft.
Using a sleeve bushing as the sealing system, the JOLLY Series slurry pumps cannot run dry under a certain level.
Capacities from 20 to 8500 gpm.
Maximum discharge pressure from 80 to 100 psi.
MEC SERIES
Designed for heavy duty slurry and/or acid applications.
The MEC Series only has direct transmission by means of an elastic joint.
There is always a metallic structure around the motor with a lifting eyebolt at the top.
Lengths under the bases are standard and do not exceed 7 ft.
Using a sleeve bushing as the sealing system, the MEC Series slurry pumps cannot run dry under a certain level.
Capacities from 20 to 8500 gpm.
Maximum available pressure from 80 to 100 psi.
AUS SERIES
Designed for heavy duty slurry and/or acid applications.
The AUS Series slurry pumps can run dry since there is no mechanical seal.
Mechanically speaking these slurry pumps are the same as the JOLLY series, but the maximum length of the AUS Series pump under the base seldom exceeds 7 ft.
Usually the fluid inlet is above the casing but in some versions it is also near the bottom (double suction impellers).
The AUS Series slurry pumps can be installed inside or outside tanks.
